Building a hang glider12/7/2023 The trick is to get the glider up in the air just before a strong puff of wind arrives.Īim the glider about 10 degrees away from the approaching puff, and tilt the wing closest to you up slightly. It’s going to take time and practice to get the most from your glider. If it plunges to the ground, sand some material off the pod. If it tends to nose up and descend repeatedly, you need more nose weight and should add a little clay. (Small trees are particularly hard on the wing’s leading edge.) Winds should be blowing at less than 8 mph.įirst make sure that you’ve got the fore and aft balance right by launching the glider very gently. To fly your glider, you need a large open area with nothing for the glider to run into. You can seal the wood with a mixture of baby powder and sanding sealer, however. It’s probably best to leave the wood unfinished, because any liquid applied to the balsa tends to warp it, and even a small tweak will ruin the glider’s flight characteristics. This prevents your finger from tearing up the trailing edge of the wing when you launch the glider, and it should be on the right side for right-handers and on the left side for southpaws (such as Bob).
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |